In this section we’ll probide assistance and information for the correct use of several of our products:

OPTIMIZED METHOD OF MULTIPLE CUT OF FLANGE BARS (POSITIONING OF BARS)

FOTOS CORTE PERFIL 001-2_edited
FOTOS CORTE PERFIL 001 edited

MINIMUM USE OF MASTIC REQUIRED ONLY ON THE CORNERS FOR "RAMI 600/120 VENTILATION DUCT"

DETALLE COLOCACION MASILLA

PLACEMENT OF THE CERAMIC GASKET 17 × 4 mm. FOR "RAMI 600/120 VENTILATION DUCT"

DETALLE COLOCACION JUNTA

ASSEMBLY TO THE LIMIT OF THE "CLIP" OF THE CORNERS TYPE "A" IN THE RAMI-30 AND RAMI-40 UNIONS. IT IS RECOMMENDED .

escuadra clip flecha 1

CORRECT METHOD OF PLACEMENT OF THE FLANGE RING IN THE DUCT:

1st: ENTER AND LOCK THE INTERMEDIATE PART OF THE FLANGE RING
2nd: ENTER THE TWO ENDS OF THE FLANGE RINGS AT THE SAME TIME
3rd: LOCK THOSE TWO ENDS
4th: LOCK THE INTERMEDIATE POINTS OF THE TWO ARCHES
5th: LOCK THE REST OF POINTS AS REQUIRED BY SIZE

EXCEL FOR THE QUICK CALCULATION OF THE TOTAL OF THE FLANGES OF EACH MEASURE TO CUT IN AN INSTALLATION AND THE AMOUNT OF CORNERS NECESSARY
If you are interested in this tool, request it at: j.ramisa@rami-system.es

EXCEL CORTE A MEDIDA PERFIL

EXCEL FOR THE QUICK CALCULATION OF THE FLANGES BUNDLE AND CORNERS BAGS THAT WILL BE NEEDED FOR THE MANUFACTURING OF AN INSTALLATION FROM A DETERMINED DUCT SURFACE.

You only have to enter the data of: Average section of the duct, length of the straight sections and percentage of figures. If you are interested in this tool, request it at: j.ramisa@rami-system.es

Image0113

TABLE FOR THE QUICK CALCULATION OF WEIGHT OF STEEL STRIP COILS

Easy to use: just multiply by the mm of strip width.
If you are interested in obtaining this tool, request it at: j.ramisa@rami-system.es

TABLA PESOS BOBINAS FLEJE

We are constantly improving and expanding the content of this section in order to continue maintaining our high service standards.
Please, come back again. Thank you for your interest!